Re:Re: [boost] Boost Serialization Tests Status
c) I don't think that gcc 2.95 can be used with the serialization
Martin Wille wrote: library.
The error messages seem to indicate this gcc doesn't have templated streams and the serialization library requires them. Perhaps some combination of gcc 2.95 - stlPort might work. I will exclude markup to skip the vanilla gcc 2.5 tests.
That's correct. The standard library implementation shipped with gcc-2 is very limit with respect to streams: no templates, no locales, etc.
I'll remove the intel-8 results again. This looks very much like there were stale .o files from the time when I didn't have enough disk space.
gcc-2 is not supported by Spirit. I planning to make Spirit 1.6.1 available for the tests.
Note that so far I know that spirit is only required for borland, msvc 6 and msvc 7.0. It's NOT needed for gcc 3.x. It might well be required for Intel 7.1 - I don't know. Robert Ramey
Robert Ramey wrote:
Martin Wille wrote:
gcc-2 is not supported by Spirit. I planning to make Spirit 1.6.1 available for the tests.
Note that so far I know that spirit is only required for borland, msvc 6 and msvc 7.0. It's NOT needed for gcc 3.x. It might well be required for Intel 7.1 - I don't know.
Thanks for the tip ;-) I was talking about gcc-2.95.3, which is not supported by Spirit 1.8 (you wrote about testing Serialization against gcc 2.95.3-stlport). Intel 7.1 works fine with Spirit. Regards, m
"Robert Ramey" wrote:
Note that so far I know that spirit is only required for borland, msvc 6 and msvc 7.0. It's NOT needed for gcc 3.x. It might well be required for Intel 7.1 - I don't know.
Spirit 1.8 works well with Intel C++ 7.0 plugged in VC6 IDE, with old Dinkumware. /Pavel
participants (3)
-
Martin Wille -
Pavel Vozenilek -
Robert Ramey