I have a program in which there is the notion of consumption rate such as
m^3/sec, gallons/hour, etc.
I have consumption_rate unit defined in terms of si units. I read in a
quanity in gallons/hour and so far so good.
If I display the quantity it is displayed as m^3/sec. This displays the
"compound units" as expected - very cool.
All this is OK as far as it goes. When I try to display the quantity as
gallons/hour again I have a whole host of
problems. The attached test fill illustrates the issues. The only way I've
been able to do is is by making
a complete end run around the units system itself - sort of self defeating.
I would appreciate insight anyone might be able to offer into this issue.
Robert Ramey
begin 666 test_units.cpp
M#0HC:6YC;'5D92 \:6]S=')E86T^#0H-"B-I;F-L=61E(#QB;V]S="]U;FET
M